Table of Contents
Advertisement
SELECTOR VALVE RELOCATION
Drill a set of Ø3/8" or Ø10MM holes 1-1/2" to the right of the existing holes on the
Leagal Rear Stow Boomrest. Install the selector valve using the hardware provided
as shown in the parts section of this manual.
SELECTOR VALVE INSTALLATION
The selector valve is attached to the boom rest as noted above. The 1/4" hoses
from the swivel section of the lift valve are plumbed to the "A" and "B" ports on the
selector valve. A run tee is added to the return section of the lift valve. Attach the 1/2"
hose from the "T" port of the selector valve to the run tee as shown in the parts section.
1/4" hoses are attached to the "A1", "A2", "B1" & "B2" ports on the selector valve to the
knuckle cylinder and swivel cylider(as shown below and in the parts section.)
ASSEMBLY
Assembly Section 2-17
Advertisement
Table of Contents
