Table of Contents
Advertisement
WEATHER-PACK/METRI-PACK ASSEMBLY
These instructions apply to both Weather-Pack and Metri-pack connectors.
NOTE: Use the specific tool for the type of connector you are assembling.
1. Apply seal to cable, before stripping
insulation.
3. Put terminal in crimping tool, then
position wire and seal in place.
INSTALLING O-RING FITTINGS
Installing straight, 45 degree and 90 degree O-ring fittings requires that the O-ring,
washer and nut (A) be up against the swivel body (B). Insert the swivel and turn in
until the swivel is pointed in the right direction and the O-ring contact is made. Hold
swivel in set direction with a wrench and turn the O-ring nut away from the swivel
body and carefully tighten.
ASSEMBLY
2. Align seal with cable insulation.
4. Crimp and visually inspect for a
good crimp before installing in
connector body.
Assembly Section 2-4
Advertisement
Table of Contents
