Console Assembly; Cup Holder Assembly; Complete Assembly - LifeSpan TR2250-HRC Owner's Manual

Console Assembly

1. Hold console on the console tube as shown in Figure 5.
2. Connect ground wires E1
3. Connect wire harness F1
4. Connect hand pulse cables G1
Note: Insert excess wire harness into right side of console tube .
6. Connect the Speed Control Harness M1
7. Connect Incline Control Harness P1
5. Fix console on the bracket by tightening 4 screws
Warning: Make sure all the cables/wires are not pinched when the console screws are tightened.

Cup Holder Assembly

1. Attach the right cup holder to the console tube and the right handlebar. Rotate the
console tube if necessary to make sure the cup holder fits snugly on the handle bar.
2. Attach screw T
3. Attach screw Q
4. Repeat the above steps to fix left cup holder on handle bar. ( FIG-7 )

Complete Assembly

Make sure the console and the cup holders
are aligned and then tighten the 4 screws S
under both sides of console tube. ( FIG-8 )
E2 . ( FIG-6 )
F2 . ( FIG-6 )
G2 . ( FIG-6 )
M2 . ( FIG-6 )
P2 . ( FIG-6 )
from the top of the cup holder onto the handlebar and tighten.
from the bottom of the cup holder to the console.
9
Q .