Installing The Repeater/Charger(S) (If Included) - Uniden BLUETOOTH XDECT R035BT Owner's Manual

Installing the Repeater/Charger(s) (if included)

1. If your phone came with any
Connect the repeater/charger power cord
accessory handsets and chargers,
connect a charger AC adapter to
each charger's
set the plug into the notch as
shown. (These adapters might
already be connected.)
2. Plug the other end of the adapter
into a standard 240V AC power
outlet.
3. To attach the stand, you have to decide if you want the repeater to
Attach the stand
rest on a desk or hang on a wall.
For desktop use, turn the stand so the locking tabs that say DEsk
are facing the base with the arrows pointing up.
OR
For wall mount use, turn the stand so the locking tabs that say
are facing the base with the arrows pointing down.
4. Align the stand with the notches on the repeater.
waLL
5. Slide the stand onto the notches until it clicks into place. (To
remove the stand, pull the locking tabs up and back. Then, slide
the stand straight off the same direction you put it on.)
6. For wall mount use, place the mounting slots (hole spacing is
Place the repeater/charger on the wall
30mm horizontal) over the pins on the wall, and slide the base
down to lock it into place.
Make sure you have a strong signal from the base (at least 3 bars
To place a Repeater/Charger
in the handset display).
x
Put the charger at least 10m away from the base or any other
Repeater/Charger. (If you put the charger on a different floor from
x
the base, don't forget to allow 10m vertically, also.)
jack and
DC IN 9V
5