Setup The Repeater/Charger(S) (If Included) - Uniden XDECT R055 Owner's Manual

Setup the Repeater/Charger(s) (if included)

Connect the repeater/charger power cord
1. If your phone came with any
accessory handsets and
chargers, connect a charger AC
adapter to each charger's
jack and set the plug
DC IN 9V
into the notch as shown. (These
adapters might already be
connected.)
2. Plug the other end of the
adapter into a standard 240V
AC power outlet.
Attach the stand
3. To attach the stand, you have to decide if you want the repeater
to rest on a desk or hang on a wall.
For desktop use, turn the stand so the locking tabs that say DEsk
are facing the base with the arrows pointing up.
OR
For wall mount use, turn the stand so the locking tabs that say
wall are facing the base with the arrows pointing down.
4. Align the stand with the notches on the repeater.
5. Slide the stand onto the notches until it clicks into place. (To
remove the stand, pull the locking tabs up and back. Then, slide
the stand straight off the same direction you put it on.)
Place the repeater/charger on the wall
6. For wall mount use, place the mounting slots (hole spacing is
30mm horizontal) over the pins on the wall, and slide the base
down to lock it into place.
4