Related Manuals for Uniden XDECT R006
Summary of Contents for Uniden XDECT R006
- Page 1 XDECT R006 For more exciting new products please visit our website: Australia: www.uniden.com.au New Zealand: www.uniden.co.nz ECT R006 OM.indd 1 15/6/10 2:13:15 PM...
-
Page 2: Important Safety Instructions
If any items are missing or damaged, contact your place of purchase. Never use damaged products! Need Help? Get answers at our website: www.uniden.com.au for Australian model or www.uniden.co.nz for New Zealand model. Important Safety Instructions! When using your telephone equipment, basic safety precautions should always be... -
Page 3: Setting Up Your Handset
Setting Up Your Handset Install the Battery 11 Unpack the handset, battery pack, and battery cover1 If the battery cover is already on the handset, press in on the notch and slide the cover down and off1 21 Line up the battery pack connector with the jack inside the handset1 (The battery connector only fits one way1) -
Page 4: Registering The Handset
Repeater. You can use the handset normally even if the repeater is not registered. Compatible bases This handset is designed for use with Uniden's XDECT R055 base1 For the most up-to-date list of compatible bases for this handset, see our website1... -
Page 5: Using The Repeater
Using the Repeater How it Works The XDECT R006 repeater works to extend the range of the XDECT R055 base in just the same way as the repeater/charger unit1 The only difference is the XDECT R006 repeater and handset-charger are separate units1 Refer to your XDECT R055 owner's manual page... -
Page 6: Registering The Repeater
Registering the Repeater Registering the Repeater is a separate process from registering the handset. On the base, open the menu and select Register Handset1 21 On the bottom of the repeater, press and hold the registration button until the light starts to lINk blink (about 2 seconds)1 Release the button and wait for... - Page 7 Picking the best spot The best spot for the repeater is as far from the base as possible while still maintaining a good signal, or near the edge of the base’s coverage area1 To find the edge of the coverage area: Stand near the base and make a call on the handset1...
- Page 8 Wall Mounting the Repeater You can mount the repeater directly to a wall using the horizontally aligned mounting slots at the back of the repeater unit1 Before doing this consider the following: Avoid electrical cables, pipes, or other items behind the mounting location that could cause a hazard when inserting screws into the wall1 ...
-
Page 9: Handling Liquid Damage
Important Information Handling Liquid Damage Moisture and liquid can damage your cordless phone1 If the handset, repeater, or charger is exposed to moisture or liquid, but only the exterior plastic housing is affected, wipe off the liquid, and use as normal1 ... -
Page 10: Battery Information
Using another charger may damage the battery pack or cause the battery pack to explode. Rechargeable Batteries Must Be Recycled or Disposed of Properly. Uniden works to reduce lead content in PVC coated cords in our products & accessories. ECT R006 OM.indd 10... -
Page 11: One-Year Limited Warranty
Improperly installed, (D) Repaired by someone other than an authorized Uniden Repair Agent for a defect or malfunction covered by this warranty, (E) Used in conjunction with any equipment or parts or as a part of a system not manufactured by Uniden. (F) Only available in the original country of sale. - Page 12 © 2010 Uniden Australia Pty Ltd/Uniden New Zealand Limited Printed in Vietnam UUZZ01229BZ(0) ECT R006 OM.indd 12 15/6/10 2:13:27 PM...
Need help?
Do you have a question about the XDECT R006 and is the answer not in the manual?
Questions and answers