Getting Started; Installing Your Phone - Uniden BLUETOOTH XDECT R035BT Owner's Manual

CAUTION! Risk of explosion if battery is replaced by an
incorrect type! Dispose of used batteries according to the
instructions. Do not open or mutilate the battery. Disconnect
For more details, see the Important Information section.
the battery before shipping this product.

GETTInG STaRTED

Installing Your Phone

Charge the battery
1. Unpack all handsets, batteries, and
battery covers. If you need to remove a
battery cover, press in on the notch and
slide the cover down.
2. Line up the battery connector with the jack inside the handset and
push the connector in until it clicks into place. Tug gently on the
wires to make sure the battery pack is securely connected.
3. Replace the cover and slide it up into place.
4. Connect the base AC adapter to the
the cord through the indent and out the back.
5. If you have accessory handsets, connect each charger's AC adapter
to the
for the repeater/chargers.)
Power Jack
6. Plug the other end of each adapter into a standard 240V AC power
outlet.
7. Place one handset in the base and the other(s) in the charger(s)
with the display(s) facing forward. The display on the handset
should light up; if it doesn't, reseat the handset or try plugging the
AC adapter into a different outlet.
#
Charge all handsets completely (about 15 hours) before using
them.
and run the cord though the indent. (See page 5
jack on the base. Run
DC IN 9V
1