Minolta CF1501 Operator's Manual page 124

7
7
On the left side of the screen, select
the pattern of the area that you wish
to be erased.
H
To erase an area all along the
outer edge of the book, touch
H To erase an area just along the
center binding of the book,
touch
H
To erase an area both along the
outer edge and along the center binding of the book, touch
(frame and center erase).
8
Touch
H
The width of the frame that is erased can be set between 1/16 and
15/16 in. (in units of 1/16 in.).
The default setting is "1/2".
H
The specified width of the area to be erased is the width before
copying. Therefore, be careful when selecting this setting while
making enlarged or reduced copies.
9
Normally, the document size is au-
tomatically detected. However,
when copying a document of a non-
standard size, touch [Original Size].
? Is it unnecessary to specify the
size of the document?
§ If the size of the document is not
to be specified, skip to step 12.
10
In the Original Size screen, touch
ify the desired size, and then touch [Enter].
The Book Erase screen reappears.
7-6
(frame erase).
(center erase).
and to specify the width that is to be erased.
Advanced Operations
, , , and
CF1501/CF2001
to spec-