Table of Contents
Advertisement
7.
Scroll down to the Promise FastTrak SX4100 (tm) Controller and click OK.
8.
When the Installer displays Promise FastTrak SX4100 (tm) Controller has
been found, click Done.
9.
Continue with the installation normally.
Note: Check the readme file, included with the downloaded driver files, for
instructions on installing the RAID Console.
Install Driver in an Existing System
1. Insert FastTrak Driver Diskette into the floppy drive.
2. Log in as root.
3. Type Run mount -r /dev/fd0 /mnt/floppy.
4. Run cd /mnt/floppy; sh ./install.
5. When the Installer asks, You are installing a driver on an existing OS. Is it true
(y/n)?, type Y and press Enter.
6. Run cd; umount /mnt/floppy.
7. Remove the FastTrak Driver Diskette and type reboot to restart the system.
Note: Check the readme file, included with the downloaded driver files, for
instructions on installing the RAID Console.
SuSE Linux 9.1, 9.2, ES 9.0
Install Driver During New OS Installation: Single Processor
1.
Insert the install CD into CD-ROM drive.
2.
When the boot: picture prompts for an installation option, add the following
line to the input box: acpi=oldboot.
3.
Press the left Alt key and insert the FastTrak driver diskette into the floppy
drive.
4.
Finish the installation normally.
Note: Check the readme file, included with the downloaded driver files, for
instructions on installing the RAID Console.
Install Driver During New OS Installation: Multi-Processor
1.
Set the BIOS to boot from the CD-ROM.
2.
Insert the install CD into CD-ROM drive.
Chapter 4: Installing Software Drivers
31
Advertisement
Table of Contents
