Table of Contents
Advertisement
5.
Under Install from Disk, type A:\wnet wnet and click OK.
6.
Under Select the device driver you want to install, click Next.
7.
If a warning about Windows Logo testing appears, click Continue Anyway.
8.
Under Completing the Found New Hardware Wizard, click Finish.
9.
If the New Hardware Wizard appears again, close it.
10. Click Yes to restart your PC.
11. Remove the Promise FastTrak Driver diskette.
12. When the Found New Hardware Wizard appears a second time, select
Install the Software Automatically (Recommended) and click Next.
13. If a warning about Windows Logo testing appears, click Continue Anyway.
14. Under Completing the Found New Hardware Wizard, click Finish.
Note: Check the readme file, included with the driver files, for instructions on
installing the RAID Console.
Confirm Installation
1.
From the Windows Desktop, open the Control Panel from My Computer.
2.
Click on Performance and maintenance.
3.
Click on the System icon.
4.
Choose the Hardware tab, and then click the Device Manager button.
5.
Click the + in front of SCSI controllers. Windows 2003 Promise FastTrak
SX4100 (tm) Controller should appear.
Windows XP
Install Driver During New OS Installation
1.
Start the installation: Boot from the CD-ROM. Press F6 after the message
"Press F6 if you need to install third party SCSI or RAID driver" appears.
2.
When the Windows Setup window is generated, press S to specify an
Additional Device(s)
3.
Insert the Promise Technology driver diskette into drive A: and press Enter.
4.
Choose WinXP Promise FastTrak SX4100 (tm) Controller from the list that
appears on screen, and then press the Enter. 1. Press S to use the driver on
the floppy disk and then press Enter to continue with installation.
5.
The Windows XP Setup screen will appear again saying "Setup will load
support for the following mass storage devices:" The list will include WinXP
Promise FastTrak SX4100 (tm) Controller.
Chapter 4: Installing Software Drivers
27
Advertisement
Table of Contents
