CYBEX VR Owner's Manual page 7

17. Place decals on weight plates according to steps listed below and Figures 3 and 4.
A. Slowly and carefully peel off back side of decal. NOTE: When peeling off back cover,
make sure that the decals remain attached to the front sticker.
B. Align holes in decal with appropriate holes in weight stack. NOTE: Do not allow the
adhesive to touch weight stack at this time.
C. Insert a guide pin through each hole of the template. NOTE: A guide pin can be
anything that fits through the weight stack hole, such as a weight stack selector pin.
D. Carefully align decal and rub it onto weight plates.
E. Carefully remove front side, leaving decals adhering to weight plates. See Figure 4.
Front
Back
Figure 3
Guide Rod
Weight Stack
Pounds
Kilograms
Figure 4
18. Place half weight on weight peg.
NOTE: It is important that you perform regular inspection and maintenance activities on
your equipment. See Chapter 7.
Cybex VR Owner's Manual
Assembly
Page 4-3