Codablock F Set Length 1 - Datalogic PowerScan PBT7100 Product Reference Manual

Codablock F — cont.

Codablock F Set Length 1

This feature specifies one of the barcode lengths for
Length 1 is the minimum label length if in
length if in
The length can be set from 003 to 255 characters.
Follow these instructions to set this feature:
1. Determine the desired character length (from 3 to 255). Pad the number with leading
2. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming
3. Scan the barcode: SELECT CODABLOCK F LENGTH 1 SETTING.
4. Scan the appropriate three digits from the keypad in the Keypad Appendix, that represent
5. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
This completes the procedure. See the table below for some examples of how to set this
feature.
Table 43. CODABLOC K F Length 1 Setting Examples
STEP ACTION
1 Desired Setting
2 Scan ENTER/EXIT PROGRAMMING MODE
3 Scan SELECT CODABLOCK F LENGTH 1 SETTING
Scan three Characters From the
4
Keypad Appendix
5 Scan ENTER/EXIT PROGRAMMING MODE
Product Reference Guide
Mode. Length includes the barcode's data characters only.
Fixed Length
zeroes to yield three digits. For example: 3 = 003, 5 = 005, 20 = 020, etc.
Mode.
the length setting which was determined in the steps above. You will hear a two-beep indi-
cation after the last character.
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the beginning.
NOTE
Mode.
003 Characters
'0', '0' and '3'
Codablock F Length Control
Variable Length
EXAMPLES
007 Characters 015 Characters
'0', '0' and '7' '0','1' and '5'
Codablock F
.
Mode, or the first fixed
050 Characters
'0','5' AND '0'
327