I 2 Of 5 Set Length 2 - Datalogic PowerScan PBT7100 Product Reference Manual

Symbologies
Interleaved 2 of 5 (I 2 of 5) — cont.

I 2 of 5 Set Length 2

This feature specifies one of the barcode lengths for
the maximum label length if in
Fixed Length
The length can be set from 2 to 50 characters. A setting of 0 specifies to ignore this length
(only one fixed length).
Follow these instructions to set this feature:
1. Determine the desired character length (from 2 to 50, or 0 to ignore this length). The
2. Pad the number with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 =
3. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming
4. Scan the barcode: SELECT I 2 of 5 LENGTH 2 SETTING.
5. Scan the appropriate two digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
This completes the procedure. See
Table 26. I 2 of 5 Length 2 Setting Examples
STEP ACTION
1 Desired Setting
Pad with leading zeroes to yield
2
two digits
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT I 2 OF 5 LENGTH 2 SETTING
Scan Two Characters From
5
Appendix E, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
216
Mode. The length includes the barcode's check and data characters.
length must be an even number.
20, etc.
Mode.
the length setting which was determined in the steps above. You will hear a two-beep indi-
cation after the last character.
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the beginning.
NOTE
Mode.
Ignore This Length
00
'0' and '0'
I 2 of 5 Length Control
Mode, or the second fixed length if in
Variable Length
Appendix E,
for some examples of how to set this feature.
Table 28
EXAMPLES
4 Characters 14 Characters
04
'0' and '4'
PowerScan
. Length 2 is
Keypad, that represent
50 Characters
14 50
'1' and '4' '5' AND '0'
PBT7100 Cordless
TM