Code 93 Set Length 2 - Datalogic PowerScan PBT7100 Product Reference Manual

Code 93 — cont.

Code 93 Set Length 2

This feature specifies one of the barcode lengths for
is the maximum label length if in
in
Fixed Length
characters. The length does not include start/stop characters.
The length can be set from 1 to 50 characters. A setting of 0 specifies to ignore this length
(only one fixed length).
Follow these instructions to set this feature:
1. Determine the desired character length (from 1 to 50 — or 0 to ignore this length). Pad
2. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming
3. Scan the barcode: SELECT CODE 93 LENGTH 2 SETTING.
4. Scan the appropriate two digits from the keypad in the Keypad Appendix that represent
5. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
This completes the procedure. See the table below for some examples of how to set this
feature.
Table 42. CODE 93 Length 2 Setting Examples
STEP ACTION
1 Desired Setting
2 Scan ENTER/EXIT PROGRAMMING MODE
3 Scan SELECT CODE 93 LENGTH 2 SETTING
Scan Two Characters From the
4
Keypad Appendix
5 Scan ENTER/EXIT PROGRAMMING MODE
Product Reference Guide
Mode. Length includes the barcode's check, data, and full-ASCII shift
the number with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20,
etc.
Mode.
the length setting which was determined in the steps above. You will hear a two-beep indi-
cation after the last character.
If you make a mistake, before the last character scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the beginning.
NOTE
Mode.
00 (Ignore This
Length)
'0' and '0'
Code 93 Length Control
Mode, or the second fixed length if
Variable Length
EXAMPLES
07 Characters 15 Characters
'0' and '7' '1' and '5'
Code 93
. Length 2
50 Characters
'5' AND '0'
317