Table of Contents
Advertisement
2.7.1.6 Setup procedure for 'Universal Repeater'
In this mode, the router can act as a wireless repeater; it can be a
Station and an AP at the same time. It can use the Station function to
connect to a Root AP and use the AP function to service all wireless
stations within its coverage.
Select Universal Repeater from the 'Mode' drop-down menu (1), and the
following will be displayed:
NOTE: For Repeater Mode, this router will demodulate the received signal,
checking if this signal is noise for the operating network then have the
signal modulated and amplified again. The output power of this mode is the
same as that of WDS and normal AP mode.
Here are descriptions of every setup item:
Band (2):
SSID (3):
Select the band you want to use, all the wireless
routers must use the same setting.
This is the name of the wireless router. You can type
any alphanumerical characters here, maximum 32
characters. SSID is used to identify your own
wireless router from others when there are other
wireless routers in the same area. Default SSID is
'default', it's recommended to change default SSID
value to the one which is meaningful to you, like
myhome, office_room1, etc.
91
1
2
3
4
5
6
7
Advertisement
Table of Contents
