Setup Procedure For 'Ap Bridge-Point To Point - Comtrend Corporation Wireless-N Broadband Router User Manual

2.7.1.3 Setup procedure for 'AP Bridge-Point to Point':

In this mode, you can connect your wireless router with another, to
combine two access points and expand the scope of the wireless
network, and all clients (wired only – AP will not accept wireless clients
in this mode) of the two wireless routers will think they're on the same
physical network. This function is very convenient when you need to
connect two networks between two buildings.
Select AP Bridge (Point to Point) from the 'Mode' drop-down menu (1),
and the following will be displayed:
NOTE: The two wireless routers must use the same mode, band, channel
number, and security setting!
Here are descriptions of every setup item:
Band (2):
Channel
Number (3):
MAC
address 1(4):
Security
Settings (5):
Select the band you want to use, the two wireless
routers must use the same setting.
Select the channel you want to use, the two
wireless routers must use the same setting.
Input the MAC address of another wireless router.
Click the 'Security Settings' button for this
connection.
(Go to section '2-7-3 Wireless Security'
for detailed instructions).
87
1
2
3
4
5