IBM N Series Hardware Manual page 256

Enabling and configuring QLOGIC BootBIOS
Perform these steps to configure QLOGIC BootBIOS:
1. Power on or reboot your host.
2. Press Ctrl+Q or Alt+Q to enter the BIOS configuration utility as shown in Figure 18-22.
Figure 18-22 Pressing Ctrl+Q for Fast!UTIL panel
3. The Qlogic Fast!UTIL displays the available adapters, listed in boot order. The primary
boot device is the first device listed. If the primary boot device is unavailable, the host
boots from the next available device in the list. Select the first Fibre Channel adapter port
and press Enter as shown in Figure 18-23.
Figure 18-23 Qlogic Fast!UTIL menu
236
IBM System Storage N series Hardware Guide