IBM N Series Hardware Manual page 221

itsosj-n1> Thu Sep 8 09:41:43 PDT [itsosj-n1: cifs.terminationNotice:warning]: CIFS: shut
down completed: disconnected workstation workstation_01.
itsosj-n1>
When you shut down an N series, there is no need to specify the cifs terminate command.
During shutdown, this command is run by the operating system automatically.
Tip: Workstations running Windows 95/98 or Windows for Workgroups will not see the
notification unless they are running WinPopup.
Depending on the CIFS message settings, messages such as those shown in Figure 16-3 are
displayed on the affected workstations.
Figure 16-3 Shut down messages on CIFS clients
To restart CIFS, issue the cifs restart command as shown in Example 16-6. The N series
startup procedure starts the CIFS services automatically.
Example 16-6 The cifs restart command
itsosj-n1> cifs restart
CIFS local server is running.
itsosj-n1>
You can verify whether CIFS is running by using the cifs sessions command. If CIFS is not
running, a message is displayed as shown in Example 16-7.
Example 16-7 Checking whether CIFS is running on the N series
itsosj-n1> cifs sessions
CIFS not running. Use "cifs restart" to restart
Use "cifs prefdc" to set preferred DCs
Use "cifs testdc" to test WINS and DCs
Use "cifs setup" to configure
itsosj-n1>
Chapter 16. Basic N series administration
201