Red Hat Enterprise Linux 5.2 Installation - IBM N Series Hardware Manual

10.Click Next again to leave the Windows creates the partition automatically window, or click
Drive options (advanced) to create the partition. Then click Next to start the installation
process as shown in Figure 18-46.
Figure 18-46 Installing Windows window
11.When Windows Server 2008 Setup has completed installation, the server automatically
restarts.
12.After Windows Server 2008 restarts, you are prompted to change the administrator
password before you can log on.
13.After you are logged on as the administrator, a configuration wizard window is displayed.
Use the wizard for naming and basic networking setup.
14.Use the Microsoft Server 2008 Roles and Features functions to set up the server to your
specific needs.
Tip: After you successfully install Windows 2008, add the remaining WWPN for all
additional HBAs to the igroup, and install the FCP Windows Host Utilities.

18.2.7 Red Hat Enterprise Linux 5.2 installation

This section shows how to install Red Hat Enterprise Linux 5.2 boot from SAN with an IBM
System x server.
Prerequisite: Always check hardware and software, including firmware and operating
system compatibility, before you implement SAN boot in different hardware or software
environments.
250
IBM System Storage N series Hardware Guide