IBM N Series Hardware Manual page 262

4. Scroll to the PCI Device Boot Priority option and select the slot in which the HBA is
installed as shown in Figure 18-35.
Figure 18-35 Selecting PCI Device Boot Priority in Start Options panel
5. Scroll up to Startup Sequence Options and press Enter. Make sure that the Startup
Sequence Option is configured as shown in Figure 18-36.
Figure 18-36 Selecting Hard Disk 0 in Startup Sequence Options panel
Phoenix BIOS 4 Release 6
To configure Phoenix BIOS to boot from the Emulex HBA, perform these steps:
1. Reboot the host.
2. Press F2 to enter BIOS setup.
3. Navigate to the Boot tab.
242
IBM System Storage N series Hardware Guide