Change Switch Access Configurations From Rear-Access (Factory Default) To Front-Access And Install; Change Switch Access Configurations From Rear-Access (Factory Default) To Front - Fujitsu XG2600 Hardware Manual

XG2600 Hardware Guide
2.2.3 Change Switch Access Configurations from Rear-Access
(Factory Default) to Front-Access and Install
This section describes how to change Rear-Access configuration (Factory Default) to Front-Access.
For Front-Access configuration to Rear-Access, make the procedure reversed.
Note
Remove rack mounting brackets
1. Remove rack mounting brackets attached to the sides of the switch.
Change the direction of fans to adjust airflow
Change the direction of fans, depending on which switch access configuration to go with, Rear-Access or Front-Access.
Check the direction of fans before installing the switch in the rack.
Airflow is as shown below.
• Rear-Access Configuration (Factory Default)
• Front-Access Configuration
Exhaust
Intake
Rack Mounting Clamps
Airflow Label
Airflow Label
36
Chapter 2 Installation
Intake
Exhaust
Installation of the switch