Defining Bandwidth Settings - D-Link DGS-3100 SERIES User Manual

DGS-3100 Series Gigabit Stackable Managed Switch User Manual

Defining Bandwidth Settings

The Bandwidth Control Page allows network managers to define the bandwidth settings for a specified interface.
1. Click QoS > Bandwidth Control. The Bandwidth Control Page opens:
The Bandwidth Control Page contains the following fields:
Field
Unit
From Port
To Port
RX No Limit
RX Rate (3500-1000000) kbps
TX No Limit
TX Rate (64-1000000) Kbps
129
Figure 4-2 Bandwidth Control Page
Description
Defines the stacking member for which the bandwidth parameters are displayed
Defines from which port number bandwidth settings are displayed.
Defines to which port number bandwidth settings are displayed.
Defines if ingress bandwidth limitation is assigned to the port. The field value
options are:
Enabled — Ensures no bandwidth limitations on the port. (This is the default
value).
Disabled —Enables ingress bandwidth limitations on the port. When
disabled, user can enter a limit value in the RX Rate field.
Specifies the maximum ingress rate on the port. The possible field range is
3500 – 1000000 Kbps
Specifies whether egress bandwidth limitation applies to the port. The possible
field values are:
Enabled — Specifies no egress bandwidth limitations on the port. (This is the
default value).
Disabled —Enables egress bandwidth limitations on the port. When disabled,
the user can enter a limit value in the TX Rate field.
Specifies the maximum egress rate on the port. The possible field range is 64 –
1000000 Kbps.