Holland Grill BH421-SS-2 Instruction Manual page 6

3. Refer to Figure 3. Select the following items:
6. Front/Rear Support Channels
7. Crossmember/Tank Support
8. Feet Inserts
9. Axle
10. Wheels
11. Push Nuts
Assemble the Front/Rear Channels (Item 6) to the legs using the long screws "B", lockwashers "C" and hex nuts "D". Next, position the Tank Supports (Item 7)
in between the Front/Rear Channels and secure with the short screws "A", lockwashers "C" and he nuts "D". Next, tap the Foot Inserts (Item 8) into the ends
of the legs at the end of the grill bottom with the drain pipe hole.
Next, install a push nut (Item 11) onto one end of the axle, tapping it into place using a block of wood and a hammer. Slide a wheel (Item 10) onto the axle
with the whitewall toward the push nut. Insert the axle through the two leg tubes and install the second wheel and push nut.At this time, carefully turn the
grill over onto its wheels and feet on a flat surface.Tighten all screws attaching the leg tubes to the grill body and end support angles.
4. Refer to Figure 4. Select the following
parts for assembly:
12. Hinges
13. Grill top stop left
14. Grill top stop right
15. Grill top
Place the grill top squarely on grill bottom.Attach both hinges to grill top and bottom with "A" screws and "C" lockwashers.Attach grill
top stops to grill bottom with "A" screws and "C" lockwashers.The flanges should point in, toward each other.
5. Refer to figure 4. Select the two shelves (part 16), and using four carriage screws "E", lockwashers "C" and hex nuts "D", attach the shelves
to the outer ends of the legs.
6. Refer to figure 5. Select the grill top handle (part 17) and attach it as shown with two "A" screws and "C" lockwashers into the threaded holes in
the grill top. Select the two stacks (part 18) and attach them to the grill top with "A" screws,"C" lockwashers and "D" hex nuts.
7. Install the short length of drain pipe in the female threaded coupling in the right end of the drip pan.Tighten with pliers or pipe wrench.
8. Open the grill top against the stops. Carefully set the drip pan in the grill bottom using the lift tabs provided at each end. Be sure the drain pipe
extends through the hole in the grill bottom.
9. Screw the brass wheel valve onto the end of the drain pipe that extends below the bottom of the grill. Hand tighten only. Be sure to open the valve.
10. Referring to figure 1, place your 20-lb propane tank bottom ring in the slots in the two tank support bars in the cart frame.
11. Position the tank top brace down tightly against the top ring of the propane tank.Tighten securely.
12. Install regulator valve onto propane tank by connecting the regulator assembly to the inlet portion of the gas cylinder valve.This connection is
made by the QCC-1 fitting.The large plastic nut fits on the outside of the threads and turns right, or clockwise, to tighten. No tools are needed. Hand
tight is sufficient. If a good connection is not achieved, the safety valve inside will not permit the proper amount of gas to flow.
13. Hang drip pail over the brass wheel valve.
14. Check all bolts and nuts for tightness and go on to leak testing. (Soapy water test. See figure 6).
8
B
C
D
14
C
A
Figure 4
p2-4
6
Figure 3
12
13
10
7
9
3
11
15
E
16
C
D