Summary of Contents for Holland Grill The Legacy BH421 SS-3
Page 1
READ THIS BOOK FIRST The Holland Grill ® Instruction Manual The Legacy BH421 SS-3 This Is A Revolutionary Gas Grill! American Gas Association Design Certified Canadian Gas Association Design Certified L.P. Tank not included. L.P. NOTICE: This grill shall be connected only to a 20 lb.
Page 2
Dear Friend, I wish to personally thank your for purchasing one of my Holland Grills. It’s my goal that you, your family and friends enjoy your grill for many years to come. It’s important that you are aware that the Holland is unlike any other grill. By design, it allows you to grill, steam or smoke, without the fear of flare-ups commonly associated with competitive brands.
The items in the fuel system are designed tings. (See final assembly instructions for THIS COOKING APPLIANCE IS FOR for operation with the Holland Grill.They more information.) OUTDOOR USE ONLY AND SHALL must not be replaced with any other brand.
Page 4
Propane gas is N.G. Holland Grill is set to operate at 7 inch- with the vapor space of the cylinder.The heavier than air and will settle in low areas.
Page 5
2. 7/16” WRENCH 3. 1/2” WRENCH 4. PHILLIPS SCREWDRIVER 5. 3/8” NUT DRIVER The Holland Grill has been designed for easy assembly. Most of the main grill body com- ponents are pre-installed at the factory.The Figure 1 items to be assembled are outlined at each step below.
Page 6
Position Grommet in Hole Refer to Figure 2c: Pedestal Regulator Hose Figure 2c Place the heat shield in position, lining up the (4) holes with the Grill Bottom andSupport Pedestal. Secure with (4) 1/4-20x5/8” bolts and Heat Shield lockwashers. Position the rubber grommet on hose into the keyhole in Support Pedestal.
Page 7
3. Refer to Figure 4. Select the following parts for assembly: Hinges Grill lid stops, left and right Grill lid Side shelves Place the grill top squarely on grill bot- tom.Attach hinges with 1/4x5/8” bolts and lockwashers.Attach lid stops to bottom using the same size bolts.
Using a small brush, soap all connections from tank to grill and look for bubbles. Correct all leaks NOTE: The Holland Grill uses a 2-posi- before proceeding. Turn off propane tion gas valve for burner control. Figure 6 tank valve.
After loading, be sure to tie down securely of cooking.To assure safe operation of your to prevent damage. Holland Grill, the area for cooking should Cylinders must be stored outdoors out of always be kept free of combustible materials NEVER transport your grill with...
A. It is important to realize cooking When done, either dip or brush on want to cook yours less or more on a Holland Grill uses a different sauce. Put back on the grill for 5 to time after checking.
Page 11
PARTS LIST FOR BH421 SS-3 LEGACY HOLLAND GRILL SS3-100 Grill Bottom, Legacy SS2-201 Stacks, Stainless Steel (2) SG4-202R Handle End, Right SG4-202L Handle End, Left SG4-250 Handle Bar, Plastic, Black SG4-210 Insulator pad, Handle Ends SG2-531 Lighting Clip and Chain (Riveted to grill bottom)
NOTE: Remember, the Holland Grill needs to warm up completely.Temperature will remain about 400 degrees F. All grilling times are approximate depending on size, weight and individual taste preference. Grill needs to remain closed at all times during grilling to be accurate with this time chart.
Need help?
Do you have a question about the The Legacy BH421 SS-3 and is the answer not in the manual?
Questions and answers