Holland Grill BH421-SS-2 Instruction Manual page 5

PREMIER II ASSEMBLY INSTRUCTIONS
Model BH421SS-2
ASSEMBLY
TOOLS NEEDED FOR ASSEMBLY
1. PHILLIPS SCREWDRIVER (MED. SIZE)
2. 3/8" NUT DRIVER
The Holland Grill has been designed for easy
assembly. Most items are pre-installed at the
factory.The items to be assembled have
been outlined in the parts list. In
addition, complete instructions and
illustrations are included in this manual.
One of the most important items is GAS
LEAK TESTING, covered under the fuel
system and lighting instructions.
1. On a flat surface (table or carport floor),
OPEN AND EMPTY ALL THREE BOXES. REFER
TO THE CONTENTS LIST TO BE SURE NO
PARTS ARE MISSING.
2. Refer to Figure 2. Select the following parts
for assembly:
1. Grill Bottom
2. Left End Support (with tank retainer)
3. Right End Support
4. Legs, left end (with axle hole)
5. Legs, right end
Set the grill bottom on a flat surface upside-down
as shown. Position the left end support angle
(with the tank) retainer) (item 2) onto the bottom
surface at the end of the body opposite the drain
pipe hole, lining it up with the threaded holes in
the body. Use the short "A" screws to attach to
body, tighten. Repeat for the support angle on the
other end.
Select the Left end legs (with axle hole) and posi-
tion leg against body side opposite the drain pipe
hole, lining leg up with threaded hole in body side
and hole in end support angle. Use the long "B"
screws to attach to the threaded holes in body, do
not tighten completely at this time. Use the long
"B" screws,"C" lockwasher and "D" hex nut to
attach the leg to the end support angle. Leave the
screws slightly loose at this time. Repeat with
other legs leaving screws loose for now.
GRILL TOP/LID
LEFT SHELF
END SUPPORT ANGLE
TANK RETAINER
YOUR 20 LB
PROPANE TANK
LEGS, LEFT END
WHEEL
Figure 1
Figure 2
B
C
B
3
1 GRILL BOTTOM
2 LEFT END SUPPORT
3 RIGHT END SUPPORT
4 LEGS, LEFT END
5 LEGS, RIGHT END
p2-3
BURNER
VALVE
REGULATOR
AND HOSE
PUSH NUT
5
DRAIN PIPE
HOLE
A
1
C
C
D
HARDWARE CODE
A #10-24 x 1 ⁄ Phillips Head (short)
2
B #10-24 x 1 ⁄ Phillips Head (long)
1
2
C #10 Lockwasher
D #10-24 Hex Nut
E #10-24 Carriage Bolt
STACKS
RIGHT SHELF
GRILL BOTTOM
LEGS, RIGHT END
DRAIN PIPE
WHEEL VALVE
DRIP PAIL
FRONT/REAR SUPPORT RAILS
AXLE HOLE
4
TANK BRACKET
2
Note Use a lock washer
under each nut where
used and each bolt
head where threads are
provided.