Chapter 11 Basic Switch Configuration; Introduction - Avaya P460 Installation And Maintenance Manual

Chapter 11
Basic Switch Configuration

Introduction

This chapter describes the parameters you can define for the chassis, such as its
name and location, time parameters, and so on.
Use the CLI commands briefly described below for configuring the display on your
terminal or workstation.
In order to...
Open a CLI session to the
alternative SPV in the P460 chassis
Display or set the terminal width
(in characters)
Display or set the terminal length
(in lines)
Display or set the prompt
Return the prompt to its default
value
Clear the current terminal display
Set the number of minutes before
an inactive CLI session
automatically logs out
Display the number of minutes
before an inactive CLI session
automatically times out
Access Layer 3 configuration if not
logged in as supervisor (see
"Access Levels" on page 55)
Enter tech mode
This command is reserved for
service personnel only
Avaya P460 Installation and Maintenance Guide
Use the following command...
session
terminal width
terminal length
hostname
no hostname
clear screen
set logout
show logout
configure
tech
63