Table of Contents
Advertisement
Firmware Download CLI Commands
In order to...
Set the default boot bank
Download firmware to Bank A
Download firmware to Bank B
Copy Device Manager (Embedded
Web) firmware
Show the default boot bank
Configuration File Management
You can transfer the Layer 2 parameters to or from the current NVRAM running
configuration file to a TFTP server.
This feature permits you to make a backup of the parameters. You can then use that
file to configure other Avaya P460 switches without re-entering all the parameters
manually.
To use this feature, you need to have an active tftp server, and to create a file
into which to download the data.
If Avaya MultiService Network Manager is running, you do not require an
additional TFTP server.
Configuration Management CLI Commands
In order to...
Upload the Layer 2 parameters
from the current NVRAM running
configuration to a file via TFTP
Update the Layer 2 parameters in
the current NVRAM running
configuration from a file via TFTP
Show the Layer 2 configuration file
Avaya P460 Installation and Maintenance Guide
Chapter 13
Use the following command...
set boot bank
copy tftp SW_imageA
copy tftp SW_imageB
copy tftp EW_archive
show boot bank
Use the following command...
copy l2-config tftp
copy tftp l2-config
show l2-config
Maintenance
75
Advertisement
Table of Contents
