Table of Contents
Advertisement
Figure 3.11
2
3
Key
1
Module label
2
Securing screws
3
Locking handles
I/O Module Installation Procedure
To install an I/O module:
1
Remove the blanking plate by unscrewing the captive screws and gently pulling
the plate towards you.
2
Open the locking handles at the edge of the front panel. See Figure 3.12.
3
Position the module as shown in Figure 3.12.
4
Gently slide the module in.
Ensure the hooks on the locking handle are aligned with the matching holes on
the chassis.
5
Close the locking handles.
The module slides back and connects to the backplane.
6
Gently tighten the screws.
For module-specific information, refer to the Installation Guide shipped with
the module.
Avaya P460 Installation and Maintenance Guide
Chapter 3
I/O Module Component Location
1
Avaya P460 Chassis and Module Installation
2
3
17
Advertisement
Table of Contents
