Positioning The Boiler; Tools And Auxiliary Materials - Buderus Logano G615 Installation And Service Instructions Manual

6

Positioning the boiler

This chapter describes how to properly position the
Logano G615.
NOTICE: Risk of system damage from
freezing.
B Install the system in a room free from the
danger of freezing.
6.1

Tools and auxiliary materials

The following tools and auxiliary materials are required for
the boiler assembly (the listed items are not contained in
the scope of delivery).
• Boiler assembly tool 2.3
• Installation kit (accessory)
• Steel hammer and wooden or rubber mallet
• Half-round bastard file
• Screwdriver (Philips and flat head)
• Flat chisel, support wedge, flat iron
• Metric wrenches
• Cleaning rags and cloth
• Fine emery cloth
• Wire brush
• 3-in-1 oil
• Solvent (gasoline, mineral spirits)
• Level, tape measure, chalk, straight edge
Logano G615 - Subject to technical modifications
Positioning the boiler
Boiler assembly tool size 2.3
4
L
2
3 2 1
Fig. 4 Boiler assembly tool size 2.3 (dimensions in
mm)
1 Mating flange
2 Additional flange
3 Compression unit
4 Tie rod
5 Extension
6 Wedge (size 2.3)
L 121 1/4" (3080 mm)
1
L 31 1/2" (800 mm)
2
Assembly
Boiler tool(s) per
sections boiler hub
9 – 16 1
Tab. 7 Boiler assembly tool size 2.3 (complete in the
toolbox)
For the correct arrangement of the flange
when performing the assembly procedure,
refer to page 21.
5
L
1
L
2
6
6 720 642 623-03.1o
Length
Extension (total) in
piece per inches
boiler hub (mm)
121 1/4
3
(3080)
6
15