Chapter 6: Technical Support - Elo TouchSystems ET3201L User Manual

Chapter 6: Technical Support

If you are experiencing trouble with your touchmonitor, refer to the following suggestions.
If the problem persists, please contact your local dealer or contact Elo Touch Solutions Customer
Service.
Solutions to Common Problems
Problem
The Touchmonitor does not respond when
turning on the system.
The Computer Module does not respond
when turning on the system.
Monitor display is dim.
Monitor display is blank.
Monitor displays an "Out Of Range"
message.
Touch functionality doesn't work.
Technical Assistance
Visit www.elotouch.com/go/websupport for online self-help.
Visit www.elotouch.com/go/contactsupport for technical support.
See this user manuals last page for worldwide technical support phone numbers.
Suggested Troubleshooting
Check that the AC power cable is properly
connected.
Verify the AC power source is functioning.
Disconnect the AC power cable and verify that the
Computer Module is properly installed. Reconnect
the AC power cable.
Use the OSD to increase the brightness.
Use the OSD to increase the contrast.
If the Power Status LED is blinking, the monitor or
Computer Module may be in SLEEP mode. Press
any key / move the mouse / touch the touchscreen to
see if the image reappears.
Adjust your computers resolution/timing mode such
that it is within the allowable timing ranges specified
for your Touchmonitor on the Elo website
www.elotouch.com.
Verify your computer or Elo Computer Module has
the latest drivers installed.
For optical units, remove and Elo driver and restart
the computer. Refer to the Setup chapters for details.
User Manual: Interactive Digital Signage
SW601990 Rev F, Page 28 of 36