Elo TouchSystems ET3201L User Manual page 20

Audio
Audio from the touchmonitor Line In, touchmonitor HDMI, touchmonitor DisplayPort, computer
module Line In, or computer module HDMI or DisplayPort ports can be played over the
touchmonitors internal speakers. See the "Audio Source" OSD parameter for details. When
headphones are plugged into the headphone output jack, the internal speakers turn off and
audio is played over the headphones.
Volume and muting of the speaker and headphone outputs can be controlled by the OSD.
MDC Functionality (For Remote Monitor Applications)
The touchmonitor has the ability to allow remote access from a host application. This is done
through the use of the Multiple Display Control command sets. By installing the IDS Utilities
Suite, the user can communicate with the monitor via the application. The host application can
send a variety of different instructions which will be executed on the IDS 01 series touchmonitor.
For detailed information, refer to the utilities suite user guide.
RFID Functionality
For 3201L and 4201L Units:
There is an integrated RFID antenna within the monitor. To enable the RFID functionality, a
RFID reader module (available at www.elotouch.com) must be installed and connected to the
integrated monitor antenna. Refer to the RFID peripheral installation guide for proper hardware
and software installation techniques.
For the 5501L and 7001L units, an external peripheral kit is available from Elo.
The list of RFID protocols that can be read are:
• ISO-14443-A
• ISO-14443-B
• ISO-15693
The RFID features Peer-to-Peer applications and the Read and Write functionality.
The location of the RFID antenna is indicated by the arrow in the following location. RFID tags
can be read at a distance of up to 40 mm away from the bezel.
User Manual: Interactive Digital Signage
SW601990 Rev F, Page 20 of 36