For Network Interface Users (For Mac Os ® X 10.2.4 Or Greater) - Brother MFC-5460CN Quick Setup Manual

Installing the Driver & Software
For Network Interface Users
4
(For Mac OS
Important
Make sure that you have finished the
instructions from Step 1 Setting Up the
Machine on pages 4 through 13.
1
Lift the scanner cover until it locks securely into
the open position.
2
Connect the network cable to the LAN socket
marked with a
LAN socket inside the machine on the left as
shown below.
3
Carefully guide the network cable to the trench
as shown below, following the trench around
and toward the back of the machine.
Then, connect the cable to your network.
Improper Setup
Make sure that the cable does not restrict the
cover from closing, or an error may occur.
®
X 10.2.4 or greater)
symbol. You will find the
Note
If both USB and LAN cable are being used, guide
both cables through the trench with one on top of
the other.
4
Lift the scanner cover to release the lock (
Gently push the scanner cover support
down ( ) and close the scanner cover (
Note
Make sure that the machine is turned on by
connecting the power cord.
5
Turn on your Macintosh
6
Put the supplied CD-ROM into your CD-ROM
drive.
7
Double-click the Start Here OSX icon to install.
Follow the on-screen instructions
Please wait, it will take a few seconds for the
software to install. After the installation, click
Restart to finish installing the software.
Macintosh
).
).
®
.
25
®