Base Enclosure - HP mt41 Maintenance And Service Manual

Base enclosure

Description
Base enclosure
Before removing the bottom cover, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
5. Remove the service door (see
Remove the base enclosure:
1. Position the computer upside down, with the battery bay facing you.
2. Remove the two front rubber screw covers (1) and (2), the one screw cover (3) on the middle left
edge, the four back rubber screw covers (4), (5), and (6), and the two back panel screw covers
(7).
Battery on page 32).
Service door on page 33).
Component replacement procedures
Spare part number
738681-001
55