Power Button Board - HP mt41 Maintenance And Service Manual

Power button board

Description
Power button board (includes cable)
Before removing the power button board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Service door (see
b. Base enclosure (see
c. USB board (see
d. Speakers (see
e. Power connector cable (see
Remove the power button board:
1. Turn the top cover upside down, with the front toward you.
2. Lift up the power button board cable (1).
3. Remove the two Phillips screws (2) that secure the power button board to the top cover.
4. Remove the power button board (3) and cable.
Reverse this procedure to install the power button board.
68 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page 32), and then remove the following components:
Service door on page
Base enclosure on page
USB board on page 64)
Speakers on page 65)
Power connector cable on page
33)
55)
66)
Spare part number
738399-001