Hardware Operation; Hard Drive Duplication - StarTech.com SATDUP13 User Manual

1 to 3 standalone hard drive duplicator and eraser

Hide thumbs Also See for SATDUP13:

Table of Contents

Hardware Operation

1. Using the Navigation buttons, locate "HDD Duplicator 1. Copy" and press OK. Default

copy mode is "System and Files". To change Copy mode please see "Setup section".

2. The duplicator will analyze the source drive and ensure all the targets are ready,

by verifying size. Once the drives have been analyzed you will receive an indicator

stating the duplicator is ready. Press OK, and the system will begin duplication

automatically.

3. Duplication will complete when the % indicator reaches 100%. The destination

drives now contain identical data to the source drive.

Note: If the destination drives are larger than the source drive, a single partition the

size of the source drive will be on the destination drive.

Instruction Manual

Table of Contents

Do you have a question about the SATDUP13 and is the answer not in the manual?