Table of Contents
Advertisement
Warnings by Lamp and Warning Tone
Warning status is indicated by tally lamp and
warning tone.
The front and back tally lamps of the camera
0
recorder appear blinking.
The warning tone is output from the monitor
0
speaker or [PHONES] terminal.
Memo :
If you continue to use the camera recorder while
0
the power warning is displayed, the camera
recorder will stop automatically when the battery
or supplied voltage from the DC power becomes
lower.
Caution :
The remaining battery power and time are
0
displayed as they are from the battery
information. Accurate data may not be displayed
depending on the battery condition. Replace the
battery as soon as possible when the remaining
battery power and time are low.
Turning On/Off the Power
Turning On the Power
1 Set the [POWER ON/OFF] switch to "ON".
The camera recorder starts up in Camera
0
mode and is ready for shooting.
The power status indicator lights up in green.
0
Memo :
The camera recorder always start up in Camera
0
mode when the [POWER ON/OFF] switch is set
to "ON".
Pressing the [CAM/MEDIA] selection button on
0
the camera recorder each time switches the
mode.
Setting [System] B [Record Format] B [System]
0
to "HD(SDI In)" or "SD(SDI In)" switches the
camera recorder to the SDI Input mode.
A B
(A P18 [Operation Modes] )
Camera Mode
Camera images are output on the viewfinder and
LCD monitor. If a recordable SD card is inserted,
the camera recorder switches to the recording
standby mode, and "STBY" is displayed on the
operation mode display area of the LCD monitor
and viewfinder.
Press the [REC] trigger button to start recording.
Memo :
Playback of SD card is not possible in the
0
Camera mode. However, you can check the
most recently recorded video clip using the clip
review feature.
(A P83 [Viewing Recorded Videos
Immediately (Clip Review)] )
Media Mode
This mode allows you to play back or delete clips
recorded on the SD card.
When a playable SD card is inserted, the thumbnail
or playback screen is displayed on the viewfinder
and LCD monitor.
USB Mode
This mode allows you to connect to a PC and
0
transfer the files on an SD card to the PC.
(Writing is not allowed)
When the camera recorder is connected to a
0
USB cable, the message "Change to USB
Mode?" appears.
Select [Change] and press the Set button to
switch to USB mode.
In USB mode, the camera recorder is
0
recognized by the connected PC as a peripheral
drive. (USB mass storage class only)
Disable the connection on the PC and remove
the USB cable from the camera recorder to
switch to Camera mode.
(A P160 [Managing/Editing Clips on a PC] )
Power Status Display
33
Advertisement
Table of Contents
