Service Program Mode; Service Program Mode Operation - Ricoh C252 Service Manual

5. SERVICE TABLES
NOTE: The Service Program Mode is for use by service representatives only so
that they can properly maintain product quality. If this mode is used by
anyone other than service representatives for any reason, data might be
deleted or settings might be changed. In such case, product quality cannot
be guaranteed any more.

5.1 SERVICE PROGRAM MODE

The service program (SP) mode is used to check electrical data, change modes.

5.1.1 SERVICE PROGRAM MODE OPERATION

To Enter and Exit the SP Mode
1. Key in the following sequence.
Method 1:
 !  !  !  ! 
Hold down Clear/Stop  for more than three seconds.
Method 2:
 !  ! Combine Key ! 
2. The SP number is displayed. (e.g. SP1)
3. To exit SP mode, press Clear Modes/Recovery .
Using the SP mode
SP command numbers can be entered directly.
1. Using the number keys, enter the desired main-menu number, then press the
Enter key.
2. Using the number keys, enter the desired sub-menu number, then press the
Enter key.
3. Enter the desired value using the number keys.
4. Press the enter key to store the displayed setting.
SM
SERVICE PROGRAM MODE
5-1 C252