Engine Maintenance Utility; Adjustment When Replacing A Part; Setting Led Head Drive Time - Oki OKIPAGE 6w Maintenance Manual

4.1.2

Engine Maintenance Utility

See Appendix D.
4.2

Adjustment When Replacing a Part

The table below lists the parts that requires adjustment when they are replaced.
LED head
EP unit
Main control board
4.2.1

Setting LED Head Drive Time

Caution: When the liminous intensity of a new LED head is the same as that of the old LED
head, do not set the LED head drive time.
Use "LED Head Making No." in the engine menu tab of the maintenance driver to set the luminous
intensity displayed on the LED head as the LED head drive time. (See Figure 4-2.)
• Luminous intensity of LED head
Part to be Replaced
Set the LED head drive time.
Set the LED Head Width
Set the LED Head Wire
Set the Head type
Reset the drum counter. (Refer to "User's Manu
Upload or download EEPROM data.
Adjustment
Luminous intensity display
402740
Figure 4-2
4 - 2
027
135
Character
This three digits indicate
the luminous intensity of the
LED head