The Okipage 6W Malfunctions After The Power Supply Has Been Turned On - Oki OKIPAGE 6w Maintenance Manual

1

The OKIPAGE 6w malfunctions after the power supply has been turned on.

• Turn the power supply off, then on again.
• Is the LED lamp on?
• No Is the AC cable connected correctly?
• Yes Is +5 V supplied between CN1 Pin 7 and CN1 Pin 13 of the high-voltage power
• Yes Is 1-2 V voltage supplied between CN1 Pin 2 and CN1 Pin 13 of the high-voltage
• Yes Replace the high-voltage power supply board(P2H).
• Yes
• No Connect the AC cable correctly.
supply board (P2H)?
(Pin 7: +5 V, Pin 13: 0 V)
• No Are the CN1 connectors of the high-voltage power supply board (P2H)
and main control board connected correctly?
• No Connect the CN1 connectors correctly.
• Yes Is +5 V supplied between CN2
Pin 2 and CN2(POWER) Pin 3 of the main control board?
(Pin 2: +5 V, Pin 3: 0 V)
• No Replace the high-voltage power supply board(P2H).
• Yes Replace the main control board.
power supply board(P2H)?
• No Replace the main control board.
Replace the main control board.
6 - 7