Developer Cartridge Installation; Toner Cartridge Installation - Sharp AR-M256 Service Manual

2) Hold the paper pressure plate and turn the fixing pin in the arrow
direction.
3) Store the removed fixing pin and the fixing screw which was
removed in the above procedure, together in the specified storage
place in the tray.
Fixing pin
Fixing screw
∗ If power is turned don without removing the fixing pin, it will be diffi-
cult to pull out the tray.

4. Developer cartridge installation

1) Hold the both sides of the front cover, and pull down to open it.
2) Loosen the blue screw and pull out the developing cartridge.
3) Remove the developer tank from the developer cartridge.
AR-M256/M257/M258/M316/M317/M318/5625/5631 UNPACKING AND INSTALLATION 5 - 3
4) Rotate the MG roller in the arrow direction and supply developer
evenly into the developing unit.
MG roller
∗ Shake the developer bag well before opening it.
∗ Check that the DV seal is free from developer. If developer is
attached to the DV seal, clean and remove it.
5) Attach the developer tank to the developer cartridge.
After supplying developer into the developer cartridge, do not tilt or
shake the developer cartridge.
6) Attach the developer cartridge to the copier, and fix it with the
screw.
Note: When replacing the OPC drum with a new one, be sure to clear
the drum count.

5. Toner cartridge installation

1) Remove the toner cartridge from the bag, shake it about 20 times
horizontally, and remove the tape.
Shake about 20 times.
Shutter
∗ When holding the toner cartridge, do not touch the shutter section,
but hold the grips. Do not remove the tape before shaking the car-
tridge.
2) Press the lock release lever, and insert the unit completely into the
copier along the guide groove. Then fix the blue screw and the
locking screw.
∗ Dirt or dust must be removed from the toner cartridge before
installing.
Tape