Sharp AR-M256 Service Manual page 76

Item Content
Current correction value of the
TH AREA5 environment correction area 5
(Grid/DVB correction)
Current correction value of the
TH AREA6 environment correction area 6
(Grid/DVB correction)
Current correction value of the
TH AREA7 environment correction area 7
(Grid/DVB correction)
Current correction value of the
TH AREA8 environment correction area 8
(Grid/DVB correction)
• When each count correction setting is "enable" in Sim44-2/3 and
each correction is reaching specified count, these are displayed.
SIMULATION 44-9
44-14
Adjustment/Setup/Operation data output/Check
Purpose
(Display/Print)
Function Used to display the environment (temperature,
(Purpose) humidity) correction information.
Item Operation
Operation/procedure
The following data are displayed.
TH AREA Current environment area
TMP DATA Detection temperature of sensor (C°)
HUD DATA Detection humidity of sensor (%)
* The value before entry of SIM is displayed. (It is not revised in real
time.)
If sim entry is just after power turned on, the display value is all 0.
SIMULATION 44-14
Default
25cpm 31cpm
0 0
0 0
0 0
0 0
AR-M256/M257/M258/M316/M317/M318/5625/5631 SIMULATION 8 - 34
44-16
Purpose Setting
The correction value for the toner density reference
Function value corresponding to the DV count value is set
(Purpose) individually for 145mm/s and 122mm/s (for the 31-
sheet machine and the 25-sheet machine).
Image process
Section
(Photoconductor/Developing/Transfer/Cleaning)
Item Operation
Operation/procedure
Set a toner density control correction value of the specified DV count.
Item
1 0K
2 2K
3 4K
4 10K Toner concentration control
5 20K correction value
6 40K (145mm/s of 31-sheet model)
7 60K
8 80K
9 100K
10 0K
11 2K
12 4K
13 10K Toner concentration control
14 20K correction value
15 40K (122mm/s of 25-sheet model)
16 60K
17 80K
18 100K
19 0K
20 2K
21 4K
22 10K Toner concentration control
23 20K correction value
24 40K (122mm/s of 31-sheet model)
25 60K
26 80K
27 100K
SIMULATION 80-19
44-17
Adjustment/Setup/Operation data output/Check
Purpose
(Display/Print)
Function Used to display the toner density control reference
(Purpose) value.
Image process
Section
(Photoconductor/Developing/Transfer/Cleaning)
Item Operation
Operation/procedure
The following data are displayed. (The displayed value is the previous
print correction value.)
TARGET Toner concentration control reference value
DEV REF Developer adjustment value
LIFE Toner container life correction value (SIM 44-16)
Content Default
55
60
50