Sharp AR-M256 Service Manual page 96

66-24
Purpose Data clear
Function
Used to clear the FAST storage data. (SEC only)
(Purpose)
Section FAX
Item Data
Operation/procedure
Select "1: YES" with the 10-key and press the [START] key. The FAST
storage data are cleared. (When "2: NO" is selected, the simulation is
canceled.)
Note: Executable only when the FAX is installed.
66-30
Purpose Operation test/check
Function (Purpose) Used to set the TEL/LIU.
Section FAX
Item Operation
Operation/procedure
When the relay state of the polarity reverse relay, the handset hook
switch, or the external telephone hook switch is changed, the content
of change is displayed regardless of the soft SW setup (real time). The
display of change is kept until an interruption command is supplied by
pressing the [CUSTOM SETTINGS] key.
Item
Signal low
HS2
HS1
RHS
EXHS
Note: Executable only when the FAX is installed.
66-31
Purpose Setting
Function (Purpose) Used to set the TEL/LIU.
Section FAX
Item Operation
Operation/Procedure
1. Enter the set value. (Valid only 0 to 8)
2. The entered bit is alternatively switched between "0" and "1" and
the target signal name is highlighted.
3. Press the [START] key to send the signal.
When the [CUSTUM SETTINGS] key is pressed, the output is terminated.
Note: Executable only when the FAX is installed.
Initializing
Notification contents
Signal high
ON OFF
ON OFF
ON OFF
ON OFF
AR-M256/M257/M258/M316/M317/M318/5625/5631 SIMULATION 8 - 54
66-32
Purpose Operation test/check
Function (Purpose) Receive data check
Section FAX
Item Operation
Operation/procedure
The fixed data received from the line are checked and the result is displayed.
When data are coincident, "OK" is displayed. When not, "NG" is displayed.
Note: Executable only when the FAX is installed.
66-33
Purpose Operation test/check
Function (Purpose) Signal detection check
Section FAX
Item Operation
Operation/Procedure
Signal detection is checked and the result is displayed.
Note: Executable only when the FAX is installed.
66-34
Purpose Operation test/check
Function (Purpose) Communication time measurement display
Section FAX
Item Operation
Operation/procedure
The send/receive test is performed, and the time required for send/
receive of the image data in the test is measured and displayed.
Communication
means
Setup on the user
Picture quality
side when executing
Density
communication
ECM
Sender information
From flag reception before sending of image
Send
data until sending of RCP frame
Measuring
range
From flag reception before reception of
Receive
image data until reception of RCP frame
Used to make communication not in a
Mode when measuring simulation process but in the normal screen
and measure the time.
1 2 3 4 5
00001
: Memory send
: Normal Character
: Lighter
: ON
: OFF