Sharp AR-M256 Service Manual page 71

26-60
Purpose Setting
Used to set enable/disable of the FAX mode key when
Function
FAX is not installed. (When FAX is installed, the FAX
(Purpose)
mode is enabled regardless of this setup.)
Item Operation
Operation/procedure
Input the set value with the 10-key and press the [START] key.
Item Content
Effective (The message with
0 ON
FAX uninstalled is displayed.)
1 OFF Disable (Error Beep)
This setup varies in connection with SIM 26-6 (Destination setup).
26-71
Purpose Setting
In the power save time setting, the pre-heat (pre-heat
mode setting) and the auto power shut off time can be
Function
set to the short time setup (pre-heat: 1 min, auto power
(Purpose)
shut off: 4 min) and the long time setup (pre-heat:
5min, auto power shut off: 30min).
Operation/procedure
Select the short time setup or the long time setup of the pre-heat time
and the auto power shut off time with the 10-key, and press the
[START] key.
Item Content
1 Preheat: 1min, auto power shut off: 4min
2 Preheat: 5min, auto power shut off: 30min
Note: When the sub code 71 is entered to display the setting menu,the
default values are always displayed. (However,the default time is
not always set.)
26-72
Purpose Setting
The letterhead support is set.
Function When "Letterhead paper setting" is selected, the set
(Purpose) value of SIM 26-46 (Image output direction setting) is
set to "Setting Enable" accordingly.
Operation/procedure
Input the set value with the 10-key and press the [START] key.
Item Content
0 OFF Letterhead paper is not set.
1 ON Letterhead paper is set.
SIMULATION 26-72
Default
JAPAN, SEC,
Others
SECL, SUK, SCA
0 1
Default
2
Default Item
0-1 0
AR-M256/M257/M258/M316/M317/M318/5625/5631 SIMULATION 8 - 29
27
27-1
Purpose Setting
Function Used to set PC/MODEM communication trouble
(Purpose) (U7-00) detection Yes/No.
Section Communication (RIC/MODEM)
Item Specifications
Operation/procedure
Input the set value with the 10-key and press the [START] key.
Item
In case of the communication trouble, U7-00 is
0 OFF
not displayed.
In case of the communication trouble, U7-00 is
1 ON
displayed.
27-5
Purpose Setting
Function (Purpose) Used to set the tag number.
Item Data
Operation/procedure
1. The currently set number is displayed on the PRESENT column.
2. Enter the new tag number (Max. 8 digits) with the 10-key.
The entered number is displayed on the NEW column.
3. Press the [START] key.
The set value is stored and "PRESENT" is revised.
30
30-1
Purpose Operation test/check
Function Used to display the sensor status attached to the
(Purpose) machine.
Section Others
Item Operation
Operation/procedure
The active sensors and detectors are highlighted.
PPD1H PS paper detection 1 sensor
PPD1L PS paper detection 2 sensor
PPD2 Fusing paper sensor
POD1 1st paper exit paper out sensor
DVCH Developing cartridge detection sensor
DRST Drum intial detection sensor
DSWR1 Interlock switch (side door)
SFTHP Shifter home position sensor
POD2 2nd paper exit paper out sensor
Operation mode (Common)
Content Default
0