Heat Sink (Thermal Module) - HP Compaq 6000 Pro Maintenance & Service Manual

Heat Sink (Thermal Module)

Description
Heat sink (thermal module), MXM graphics
Heat sink (thermal module), UMA graphics
The heat sink is secured with nine screws. You do not have to remove the large fan to remove the heat
sink. You have to remove the small fan to remove the heat sink.
To remove the heat sink:
1.
Prepare the computer for disassembly (see
2.
Remove the small rear cover (see
3.
Remove the port cover (see
4.
Remove the stand (see
5.
Remove the drive cover (see
6. Remove the memory cover (see
7. Remove the upper rear panel (see
8. Remove the small fan (see
9. Remove the screw at the top of the heat sink (1).
10. In the order indicated by the numbers stamped into the heat sink, remove the six screws (2) that
secure the heat sink to the system board.
11. Loosen the two captive screws (3) that secure the heat sink to the system board.
Figure 7-21
12.
Lift the heat sink off the system board.
To replace the heat sink, reverse the removal procedures.
Small Rear Cover on page
Port Cover on page
Stand on page
Optical Drive on page
Memory on page
Upper Rear Panel on page
Small Fan on page
Removing the heat sink
Preparing to Disassemble the Computer on page
40).
41).
42).
43).
48).
56).
Spare part number
625255-001
625256-001
50).
Heat Sink (Thermal Module)
39).
57