Hood Sensor - HP Compaq 6000 Pro Maintenance & Service Manual

Hood Sensor

The hood sensor is located just below the fan sink. It is secured with one screw and has one connector.
Figure 7-42
To remove the hood sensor:
1.
Prepare the computer for disassembly (see
2.
Remove the small rear cover (see
3.
Remove the port cover (see
4.
Remove the stand (see
5.
Remove the drive cover (see
6. Remove the memory cover (see
7.
Remove the upper rear panel (see
8. Remove the I/O panel (see
9. Remove the outer/left panel (see
10. Remove the tape (1) and screw (2) that secure the board to the computer.
80 Chapter 7 Removal and Replacement Procedures All-in One (AIO) Chassis
Hood sensor location
Small Rear Cover on page
Port Cover on page
Stand on page
Optical Drive on page
Memory on page
I/O Panel on page
Outer/Left Rear Panel on page
Preparing to Disassemble the Computer on page
41).
42).
43).
48).
Upper Rear Panel on page
62).
40).
50).
70).
39).