XSARA
B1EP11DC
B1EP11EC
CHECKING AND SETTING THE VALVE TIMING
Setting the valve timing.
Loosen the screw (2), remove the belt.
Loosen the six pulley screws (1) on the hubs (there should be a slight amount of friction between the screws and
the pinions) .
Check that the rollers (2) and (3) rotate freely.
NOTE: The belt bears three identification marks (a), (b) and (c), facing its own teeth (1), (52) and (72) respectively
(identification marks = white paint lines on the back of the belt facing the corresponding teeth) .
Refit the belt.
Line up mark (A) on the belt with groove (D) of the pinion (4).
Hold the belt against the pinion (4).
Engine: NFU
194