JUMPER
B1BP2J5D
AUXILIARY EQUIPMENT DRIVE BELT
Without air conditioning
[1] Dynamic tensioner compression lever
[2] Dynamic tensioner roller retaining peg Ø 4 mm
Removing.
Remove the splash-shield, under-engine sound-deadening, front RH wheel.
WARNING: Mark the direction of fitting of the auxiliaries drive belt in the case of
re-use of the belt.
Compress the dynamic tensioner roller (1) by acting at «b» (anti-clockwise) , using tool [1].
Peg using tool [2] at «a».
IMPERATIVE : Check that the roller (1) turns freely (without play and without tight
spots) .
Refitting.
Refit the auxiliaries drive belt.
IMPERATIVE: Make sure that the auxiliaries drive belt is correctly positioned in
the grooves of the various pulleys.
Compress the dynamic tensioner roller (1) by acting at «b», using tool [1].
Remove tool [2] at «a».
Complete the refitting.
180
Engines: RHV - 4HY
Tools.
: (-).0188.Z.
: (-).0188.Q1