Table of Contents
Advertisement
154
Buffalo Surveillance Server
Field
Preset position select
Information addition
When you are finished changing your motion detection settings, click [ SET ].
Preset position select
Beneath the video feed on the VMD area tab find the Video area setting for Preset
position section. Select [ Setup ] to the right of Preset position select. The VMD area
page (for Position No.1) will appear:
Each color-coded section represents one motion detection area. You can define up to four
areas.
If you set Preset position select options, settings on the VMD area tab will be ignored.
Change the covered areas to suit your needs by (1) deleting current areas and (2) creating
new ones by dragging your cursor across the area you want covered.
Setting the Detection sensitivity.
Enables you to define up to four discrete motion detection
areas. If you do not select areas or all individual areas are
deactivated, the system will detect motion in the entire,
default area defined by the white square on the VMD area
page.
Each camera supports up to four motion detection areas.
This is the part of the camera's field of view for which motion
is monitored. By default, the entire field of view is selected.
You can change covered areas to suit your needs by (1)
deleting current areas, (2) creating new ones by dragging
your cursor across the area you want covered, and (3)
setting detection sensitivity.
See the Preset position select section immediately below
this table for detailed directions for creating motion detection
areas.
Should be set to OFF. Adds additional information, such as
timestamp, that the Buffalo Surveillance Server does not use.
Function
Advertisement
Table of Contents
