Error Display - Canon Pixma iP1600 Pixma iP1200 Service Manual

3. ERROR DISPLAY

Errors are displayed by the LEDs, and ink low warnings are displayed by the Status Monitor.
3-1. Operator Call Error (Alarm LED Blinking in Orange)
Alarm LED
blinking
2 times No paper
3 times Paper jam
4 times No ink
5 times The ink cartridges are not properly
installed, or a non-supported ink cartridge
is installed (the ink cartridge EEPROM
data is abnormal).
7 times Ink cartridge not installed
8 times Waste ink absorber full or platen waste ink
absorber full warning (approx. 95% of the
maximum capacity)
14 times Non-supported ink cartridge installed
16 times Used ink cartridge installed, or no ink
3-2. Service Call Error (Cyclic Blinking in Orange (Alarm LED) and Green (Power LED))
Cycles of blinking
in orange and
green
2 times
3 times
7 times
8 times
9 times
10 times
Error
Error
Carriage error
LF error
Waste ink absorber full or platen waste ink
absorber full
Print head temperature rise error
EEPROM error
No ink cartridge detected excepting ink
cartridge replacement (during printing)
Set paper, and press the Resume/Cancel button
to feed the paper.
Remove the jammed paper, and press the
Resume/Cancel button.
Replace the ink cartridge(s), or press the
Resume/Cancel button to continue printing
without replacing the ink cartridge(s).
Install the ink cartridges properly.
Or, confirm that the supported ink cartridges are
installed.
Install the ink cartridge(s), and close the access
cover.
Pressing the Resume/Cancel button will exit the
error, and enable printing.
Replace the non-supported ink cartridge with the
supported one.
Pressing the Resume/Cancel button will exit the
error, and enable printing.
Replace the printer as it has failed.
Replace the printer as it has failed.
Replace the printer as it has failed.
Replace the printer as it has failed.
Replace the printer as it has failed.
Replace the printer as it has failed.
(6/23)
Corrective action
Corrective Action