Rf 433Mhz Communication Setting For Handheld Unit - Newland NLS-HR2180 User Manual

RF 433MHz communication setting for Handheld unit

Handheld unit RF channel No.: The scanner offers eight different radio frequency channels for the data
transmission between handheld unit and cradle.
Handheld unit ID: The scanner offers 16 different handheld unit IDs.
Example: to set a handheld unit to work on channel 2 with ID 15.
Steps: Scan the following barcodes in order.
RF power level: By selecting, you can change the radio frequency power level for handheld unit.
Frequency hopping: If it is enabled, the scanner is able to pick up a higher-performance radio frequency
channel from a group of channels in terms of consolidated communication.
RF operating mode:
Normal- Do not batch data. The handheld unit attempts to transmit every scanned barcode. If the
transmission is failed, the barcode data is ignored.
Out-of-range batch－ The handheld unit starts storing barcode data when it loses its connection to a
remote device (for example, when a user holding the handheld unit walks out of range). Data
transmission is triggered by reestablishing the connection with the base (for example, when a user
holding the handheld unit walks back into range).
Enter Batch Mode
Standard batch- The handheld unit starts storing barcode data after "%%%EBM" ( ) is
Send Batch Data
scanned. Data transmission is triggered by scanning "%%%SBD" ( ).
In Out-of-range batch or Standard batch modes, calculate the number of barcodes the handheld unit can
store as follows:
Number of storable barcodes = 16,384 bytes of memory / (number of characters in the barcode + 2).
Beep on reconnect attempt: This feature is active only when the Out-of-range batch operating mode is
selected. If this feature is enabled, the beeper emits 4 short beeps every 5 seconds while the
reconnection attempt is in progress.
Radio connection checking interval: This feature is active only when the Out-of-range batch operating
mode is selected. The handheld unit checks the radio communication with the base once within the
time interval.
Save data at low-battery or power-off: If it is enabled, the handheld unit will save data to memory while
the battery is low or before the power is off.
Low battery indicator: If it is enabled, while the power is low, the power LED on the handheld unit flashes
5 times, and the beeper emits 5 beepers for every 10 minutes or 200 scans. In this battery low status,
the power LED flashes 2 times by pulling the scanner trigger.
19
nlscan.com